Assembly Procedure PC8000 1. Mounting of Crawler Segments to the Side Frames: Z22917 1. Position the crawler plate segments as shown (3 eyes pointing to the idler wheel) on flat ground so that pin (03) enters easy (48 track pads each side). 2. Slide in pins and secure them with the items(05, 06 + 07) Insert bolts (05) the right way so that the bolt head will come in contact with the pin (03). Hardened portion of bolt head (colored marking) must point to pin (03) (refer to SB AH00513A). Tighten nut and spot weld nut (06) with the threaded bolt end (05). 3. Push back the track tensioner cylinder by means of opening the cock valve in the side frame. 4.
Position the side frame on top of the chain in a way that the idler wheel stays two track pads back from the end of chain. W Support side frame properly! DANGER OF ACCIDENT! 5. Lift with a crane the other end of the chain and fold it over the sprocket so that the drive nudges hook up in the sprocket teeth, lower the chain end and close up over the idler wheel. 6. With a Porto Power Pump connected to feed line of the track tensioning system tension the track chain properly (This will allow easier mounting of the side frame to the car body ) close up cock valve behind the tensioner cylinder. ) Closing the chain after mounting the final drives because of the width of the crawler segments.
(Refer to page 31). PC8000AS rev 02.doc 23 Edition 01/2004