3.3.27. Oil filter Install the oil filter onto the cylinder block, and tighten the fixing bolts. With the hollow screw, assemble the oil pipe connected between the oil cooler and cylinder block. Install a connection pipe between the oil cooler and oil filter. Assemble the cartridge using a filter wrench. 3.3.28. Injection pump Install the injection pump bracket in the cylinder block. After measuring the amount of run-out with an alignment setting jig, disas- semble the bracket, adjust the shims, then reassemble it. Mount the top/bottom adjusting shims in the bracket and then mount the fuel injection pump. Tighten the fixing bolts in a diagonal sequence to specified torque.
- 92 - REASSEMBLY EAMD107I EA MD107I Run out 0.2 mm or less Torque 4.4 kg.m