Group 43 MID 130 Transmission Control Unit, Fault Codes MID 130 PPID 50 Clutch, Pre-load MID 130 PPID 51 Clutch Disc, Pull Position 25 Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause: FMI 0 • Data valid but above normal operational range • The calculated stored energy is above 200 kJ • The energy calculation is time based for VTNA and physical for others • Yellow lamp is sent • The clutch is overheated • The clutch is slowly engaged • N/A FMI 11 • Clutch protection active (unidentifiable error) • Clutch slip more than 8.0 s with vehicle movement less than 0.8 m (e.g.
hill holding event) • Yellow lamp is sent • There has been unnecessary clutch slip • The clutch is slowly engaged • N/A FMI 14 • Special instructions • Attempt to start in high range in manual position • White lamp is sent • Not possible to start • N/A Type of fault: FMI Description: Fault Condition: Possible Symptoms: Possible Cause: FMI 13 • Calibration value out of range • The checksum in NVRAM is not correct • The slip point has not been calibrated • Yellow lamp is sent • It is not possible to drive the vehicle • N/A