INTRODUCTION FASTENER INFORMATION 3. Choose proper strength Loctite threadlocker. 4. Fit bolt in the hole. 5. Apply a few drops of threadlocker at proposed tightened nut engagement area. 6. Position nut and tighten as required. SELF-LOCKING FASTENERS PROCEDURE Threadlocker Application for Blind Holes A00A6LA TYPICAL SELF-LOCKING FASTENER The following describes the most common appli- cation procedures when working with self-locking fasteners. Use a metal brush or a tap to clean the hole prop- erly then use a solvent, let act during 30 minutes and wipe off. The solvent utilization is to ensure the adhesive works properly. lmr2007-040-004_a 1. On threads 2.
On threads and at the bottom of hole LOCTITE ® APPLICATION PROCEDURE 1. Clean threads (bolt and hole) with solvent. 2. Apply LOCTITE PRIMER N (P/N 293 800 041) on threads (bolt and nut) and allow to dry for 30 seconds. 3. Choose proper strength Loctite threadlocker. 4. Apply several drops along the threaded hole and at the bottom of the hole. 5. Apply several drops on bolt threads. 6. Tighten as required. The following describes the most common ap- plication procedures when working with Loctite products. NOTE: Always use proper strength Loctite prod- uct as recommended in this shop manual.
Threadlocker Application for Uncovered Holes (Bolts and Nuts) Threadlocker Application for Stud in Blind Holes 1. Apply here 2. Do not apply 1. Clean threads (bolt and nut) with solvent. 2. Apply LOCTITE PRIMER N (P/N 293 800 041) on threads and allow to dry. lmr2007-040-005_a 1. On threads 2. On threads and in the hole 3. Onto nut threads 1. Clean threads (stud and hole) with solvent. XVI smr2009-011