INTRODUCTION 2. Apply LOCTITE PRIMER N (P/N 293 800 041) on threads and allow to dry. 3. Put 2 or 3 drops of proper strength Loctite threadlocker on female threads and in hole. NOTE: To avoid a hydro lock situation, do not ap- ply too much Loctite. 4. Apply several drops of proper strength Loctite on stud threads. 5. Install stud. 6. Install cover, etc. 7. Apply drops of proper strength Loctite on un- covered threads. 8. Tighten nuts as required. Threadlocker Application for Adjusting Screw Threadlocker Application for Pre-Assembled Parts 1. Apply here 2. Plunger 1. Adjust screw to proper setting. 2. Apply drops of proper strength Loctite thread- locker on screw/body contact surfaces. 3.
Avoid touching metal with tip of flask. NOTE: If it is difficult to readjust, heat screw with a soldering iron (232°C (450°F)). 1 Application for Stripped Thread Repair 2 A00A3OA 1. Apply here 2. Do not apply 1. Clean bolts and nuts with solvent. 2. Assemble components. 3. Tighten nuts. 4. Apply drops of proper strength Loctite on bolt/nut contact surfaces. 5. Avoid touching metal with tip of flask. NOTE: For preventive maintenance on exist- ing equipment, retighten nuts and apply proper strength Loctite on bolt/nut contact surfaces. 1. Release agent 2. Stripped threads 3. Form-A-Thread 4. Tapes 5. Cleaned bolt 6. Plate 7. New threads 8.
Threadlocker Standard Thread Repair Follow instructions on Loctite FORM-A-THREAD 81668 package. If a plate is used to align bolt: 1. Apply release agent on mating surfaces. 2. Put waxed paper or similar film on the surfaces. smr2009-011 XVII