Kubota — Adjusting Parking Brake

61 PERIODIC SERVICE EVERY 200 HOURS B Changing Engine Oil To avoid personal injury: A Be sure to stop the engine before changing the oil. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Park the vehicle on a flat surface and raise the cargo bed. 2. To drain the used oil, remove the drain plug at the bottom of the engine and completely drain the oil into an oil pan. All the used oil can be drained out easily when the engine is still warm. 3. After draining, reinstall the drain plug. 4. Fill with the new oil up to the upper notch on the dipstick.

(See "LUBRICANTS, FUEL AND COOLANT" in "MAINTENANCE" section.) (1) Drain plug (2) Rear tire (LH) B Adjusting Parking Brake C Adjusting procedure 1. Release the parking brake. 2. Loosen the lock nut, and adjust the cable wire length. 3. Tighten the lock nut, and check the free play. (1) Parking brake lever (2) Lock nut (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range Proper parking brake lever free play range 1 notch Oil capacity [Filter exchanged] 4.1 L (4.3 U.S.qts.) [Filter non-exchanged] 3.8 L (4.0 U.S.qts.)