PERIODIC SERVICE 62 B Replacing Engine Oil Filter B Replacing Transmission Oil Filter [HST] To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. To avoid personal injury: A Be sure to stop the engine before changing the oil filter. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Park the vehicle on a flat surface and raise the cargo bed. 2. Remove the oil filter. 3. Put a film of clean engine oil on the rubber seal of the new filter. 4. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the engine oil normally decreases a little. Make sure that the engine oil does not leak through the seal and be sure to check the oil level on the dipstick. Then, replenish the engine oil up to the prescribed level. 1. Park the vehicle on a flat surface, raise the cargo bed, and mount the safety support. 2. Remove the oil filters. 3. Put a film of clean transmission oil on the rubber seal of the new filter. 4. Quickly tighten the filter until it contacts the mounting surface, then, with a filter wrench, tighten it an additional 1 turn only. 5. After the new filter has been replaced, fill the transmission oil up to the upper notch on the dipstick. 6.
After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 7. Make sure that the transmission fluid doesn't leak past the seal on the filters. (1) Engine oil filter (1) Transmission oil filter (HST) (Yellow color) A To prevent serious damage to the engine, use only a KUBOTA genuine filter. A To prevent serious damage to the transmission, use only a KUBOTA genuine filter.