OM2032 03/13 Safety - Section 20 Page 20-11 2. Remove cable (2) from its stored position on the body and install between dump body (1) and the axle housing ear. 4. Move the hoist lever to the FLOAT position to slowly lower the body until the cable is support- ing the full weight of the body. Then move the hoist lever to the HOLD position. 3. Secure the cable clevis pins with cotter pins. 5. After maintenance is complete, return the cable to the stored position. FIGURE 20-1. SECURING THE DUMP BODY 1. Dump Body 2. Body Retention Cable