Safety - Section 20 03/13 OM2032 Page 20-12 DURING MAINTENANCE Rules To Follow When Adding Fuel Or Oil Spilled fuel and oil may cause slipping. Always clean up spills, immediately. Failure to clean up fuel or oil spills may lead to fires. Personnel Only authorized personnel may service and repair the machine. Always tighten the cap of the fuel and oil fillers securely. Attachments Never use fuel to wash parts. Place attachments that have been removed from the machine in a safe place and manner to prevent them from falling. Always add fuel and oil in a well-ventilated area.
Working Under The Machine Always lower all movable work equipment to the ground or to their lowest position before performing service or repairs under the machine. Always block the tires of the machine securely. Radiator Water Level If it is necessary to add coolant to the radiator, stop the engine, and allow the engine and radiator to cool. Never work under the machine if the machine is poorly supported. Keep The Machine Clean Depress the pressure release button on the cap to vent cooling system pressure. Spilled oil or grease, scattered tools, etc. can cause you to slip or trip. Always keep the machine clean and tidy. Slowly loosen the cap to relieve any remaining pressure during removal.
If water gets into the electrical system, there is danger that the machine may move unexpectedly and/or damage to components may occur. DO NOT use water or steam to clean any sensors, connectors, or the inside of the operator's compartment. Use Of Lighting When checking fuel, oil, coolant, etc., always use lighting with anti-explosion specifications. If such lighting equipment is not used, there is danger of explosion.