3. Operation 3.2.4 Supply Cooling Wat er (For Fresh Wat er Cooling Type Only ) Supply cooling water according to the following procedures. Be sure to add antirust or antifreeze to the cooling wa ter. 1. Be sure to close the 3 water drain cocks (See illustration right). I Note: The water drain cocks are opened Filler port before shipping from the plant. @ Upper limit @ Lower lim it ® Bonnet ® Dipstick 3.2.3 Supply Cl ut c h Lube Oil 1 . Remove the filler port cap at the top of the bonnet, and fill with marine gear- clut ch- lu be oil. 2. Fi ll with all to the upper limit on the dlpstick. Insert the dipstick fully to check the level. 3. Tighten the filler port cap securely by hand. , ~ .
I --:::::::~~~- - Wat er drain co~ M arine gear o il capacity KM2P KM3V KM3P 0.3 I 0.8 I 0.35 I Fresh water cooler G) Exhaust manifo ld 2. Remove the filler cap of the fresh water cooler by turning the cap counterclock- wise 1/3 of a turn. Oil filler port cap Filler cap @Den ts Ci) Fresh water cooler @ Notches G) Upper lim1Vlower limit @Dipst i ck 23