2-2 CAB AND FRAME GENERAL DESCRIPTION General Description This Section describes the installation and removal procedures for the main parts related to the N series body (cab). Each service procedure is applicable to all N series unless otherwise specified. BUMPER Front Bumper (Except NPS Rigid Axle Model) N2A0007E Legend 1. Fog lamp fixing nuts 5. Air guide (Independent suspension) 2. Front bumper reinforcement 6. Air guide fixing bolts 3. Front bumper assembly 7. Air guide (Rigid suspension) 4. Fog lamp assembly Removal 1. Air guide fixing bolts Remove the rear-side bolts/washers fixing the air guide. 2.
Front bumper assembly Remove the two fixing bolts on each side of the left and right front bumper assembly. And disconnect fog lamp harness connection. 3. Front bumper reinforcement Loosen the fixing nuts and bolts, and clips and pull them out. (1) (2) (3) (4) (5) Wide Cab Nut Clip Clip Clip Bolt Others than Wide Bolt Bolt — Clip Bolt