2-6 CAB AND FRAME Removal 1. Front wiper arm (2) Caution: If the painted surface is scratched, this causes rust. Open the cover (1) and remove the fixing nut (3). 7. Room mirror stopper rubber 8. Front pillar grip/trim cover Refer to “Front Side Trim Cover” in Interior & Exterior Trim Section. 9. Front window finisher (10) Pull it from body flange. Don’t reuse it. N2A0013E 2. Clearance lamp Refer to “Lighting System”. 3. Outside mirror stay cap/front panel side/sub cover 4. Outside mirror assembly/outside mirror attach- ment/molding Refer to “Outside Mirror Assembly” in this Sec- tion. 5. Ornament grille upper molding (5) N2A0015E 10.
Front window glass (11) Pass the piano wire (12) of φ 0.5 mm or so to the room inside through the adhesive part (13) of front window glass. Bind both ends of this piano wire on the wooden piece (14) etc., and cut the adhering part in the whole periphery of the glass moving it back and forth inside and out- side the room. Remove the glass. Remove the lower part (6) of upper molding from ornament grille (7) with a bladed screw- driver. N2A0014E 6. Front window molding (8) Remove it according to the same procedure as step 3. Don’t reuse it. N2A0016E