CAB AND FRAME 2-7 Caution: Completely remove the adhesive remaining on the body flange and perform cleaning. If there is any convex or concave portion, this causes imperfect contact when in- stalling the glass, leading to cracks or water leakage. To reuse the removed glass, perform the same treatment on the adhering surface of the glass side as well as the flange side. When the glass is an adhesion type, take care not to damage the glass stopper which must be re- used. If the painted surface of the body flange is scratched, this will cause rust. Accordingly, repair it completely.
N2A0018E Temporarily set the front window glass (3), perform positioning marking so that the left/right clearance (5) may be uniform. Next, when the top clearance (4) is equal to the left/right clearance, proceed to the installation step. At this time, If the clearance must be adjusted, remove the ornament grille and adjust the glass stopper. Refer to “Ornament Grille” in Interior & Exterior Trim Section for removal of ornament grille. N2A0017E Installation Preparation Be sure to perform the position alignment check of the front window glass before installation. Be sure to use a new front glass finisher (1). Set the deposit (2) in the central lower part.
Insert the flange sequentially from the deposit. After setting, proceed to the next step without peeling off the ex- foliate paper of two-sided adhesive tape. N2A0019E