OPERATION 9. EXPLANATION OF COMPONENTS Right control lever (2) REMARK Use this lever to temporarily raise or lower the speed set by the engine speed control switch described on "SWITCHES(3-10 page)". 9.1.2 OPERATION METHOD FOR BLADE, DUAL TILT, AND PITCH USING RADIO CONTROL Switching between dual and single mode 1. Set the blade/ripper selector switch to the blade position. 2. Keep the blade FLOAT switch pressed, operate the lever fully to the left or right, and hold in position for approx. 2 seconds. 3. Each time the above operation in Step 2 is carried out, the mode is switched between dual mode and single mode. 4.
When right control lever (1) is operated, the blade is tilted (dual tilt or single tilt). Left tilt: Operate lever to left Right tilt: Operate lever to right REMARK When operating by radio control, it is possible to switch the mode regardless of the position of the dual tilt/single tilt selector switch on the blade lever. The mode when the control method is switched from on-board radio control depends on the position of the dual tilt/single tilt selector switch on the blade lever. The mode when the control method is switched from radio control on-board depends on the position of the dual tilt/single tilt selector switch on the blade lever.
3-7 Direction of operation Front / rear direction Right control lever (2) Push Pull Deceleration Acceleration