Precautions When Using ROPS SAFETY Never modify, weld, cut, or drill on any part of a ROPS structure. Doing so may weaken the structure which could lead to possible failure in a rollover situation. The ROPS (Roll Over Protective Structure) must never be removed from the machine. The ROPS is installed to protect the operator if the machine rolls over. It is designed not only to support the load if the machine rolls over, but also to absorb the impact of the energy. The ROPS fulfills all the regulations and standards for all countries. If it is modified without authorization or is damaged, the strength may be reduced and it may not be able to fulfill its function properly.
Never drill, cut, weld on, or modify the ROPS structure. If the ROPS structure should become damaged in any way, replace it immediately. Do not make repairs to the ROPS structure itself. Emergency Escape from Operator’s Cab If the left door of the cab does not open or if it is dangerous to get off the machine from the left side, release the open lock of the right door (emergency door) and use the right door as an emergency escape route. See “Emergency Escape Right Door” on page 2-69.. WA380-6 1-17