3 i5601E Digital Display Monitor Settings Default Monitor NOTICE This setting should be used with caution since some calibration data and user settings may be lost. The “Default Monitor” function resets all monitor settings for the display unit back to the default values. Press OK! to reset your i5601E or press BACK to cancel. To reset all system settings use “Set System Defaults” command shown on page 3:42. CAUTION On 6CX Systems, if the “Default Monitor” command or the “Set System Default” command is selected the system will revert to a 6LY3 System and will need to be reset to a 6CX System.
Beeper About The “About” screen displays useful information about your i5601E, such as part number and software version. This information may be needed by Yanmar Customer Support in the event you contact them. © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 3:23 Display Choice Function ON Turns on Audible Beeper OFF Turns off Audible Beeper