3 i5601E Digital Display Factory Settings Factory settings Introduction Complete List of Factory Settings: Eng Display Enter Idle RPM (BY engines -only with the 4.0 software or newer) Sync Lead Engine T Engage Delay Troll Valve Setup Fixed Shift Dly Set System Defaults System Select Note: This list will vary according to engine type and selected options. The Factory Settings menu allows setting the configuration specific parameters. This includes unit definitions such as Port and Starboard, type of electrical/mechanical interfaces, and various timing and scaling values. All of these are critical to the system and require a thorough knowledge of the system to undertake any changes.
This area is passcode protected and will require successful code entry to allow entry of any parameter. Note: the right arrow will not appear if code was not entered. Settings Password Code Entry The entry of the Password code is triggered by the selection of the Factory Settings Entry from the Main Menu. The buttons labeled “1”, “2”, “3”, & “4” are used to enter the respective digit of the 4 digit password code. Repeated pressing of the digit button will cause an incrementing of the digit’s value, which is displayed in the window above. Upon completion of the 4 digit code, the “Enter” button is pressed and the code will be validated.
Once the code is entered the “Unlocked” status will remain until the i5601E is powered off and on. Consequently no further prompting of password will occur. The default code is 3124. © 2011 Yanmar Marine International • Rev. 2.0 3:40 Yanmar Electronic Control Systems Technical Manual