SAFETY PRECAUTIONS SECTION 2 Page 9 GENERAL MAINTENANCE PRECAUTIONS Use extra caution when adjusting the loader's bucket leveler or boom kick-out. Use two trained people and guard against accidental movement of the machine or loader linkage. The roll-over protective structure (R.O.P.S.) provides operator protection in the event of machine rollover or upset. It is designed to bend during a rollover to protect the operator from sudden impact loads. Do not attempt to repair a R.O.P.S. after an accident. Repaired structures do not provide the original strength and protection. Contact the Authorized Distributor of Construction Equipment for information on R.O.P.S. (or cab) replacement.
Do, not operate the machine again until the R.O.P.S. has been replaced. Periodically inspect the R.O.P.S. for fatigue cracks. Cracks indicate a weakened structure which should be replaced for your protection. Bolts fastening cab or R.O.P.S. must be torqued to specific value. Do not cut, grind, weld, drill or tap holes in the R.O.P.S. This could weaken the structure or affect the overall energy absorption capability. Always wear the seat belt during all operation in order to realize protection of the R.O.P.S.( or cab) When transporting the machine, lock the frame halves together with the frame locking bar and pins. Corrosion inhibitors are volatile and flammable.
Use them only in a well ventilated area. Keep flames and sparks away. Do not smoke. Store container in a cool, well ventilated place. For your safety never push or tow a disabled machine farther than absolutely necessary. When using a chain or cable, be sure it is strong enough for the expected load and properly secured to the drawbar pin or towhook. Avoid kinking. Do not pull with a kinked chain or cable because the high stresses could cause failure in the kinked area. Wear heavy gloves when handling chain or cable.When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury.
Do not pull or tow unless the operator's compartment is guarded against or out of reach of a whipping chain or cable. Hitch only to the drawbar pin or towhook. Prior to towing release the parking brake. Rims and tires must be repaired in specialized shops featuring proper technology. Improper repairs may result in malfunctions and accidents. Never inflate a flat tire without inspecting the tire and rim for damage. Be sure the components are properly assembled. Unmounted tires being inflated or deflated should be placed in a tire safety cage. Inflate the tire to 35 kPa and check that all components are properly seated. Never stand directly in front of a tire and rim assembly while inflating.
Use a clip-on chuck with a hose long enough to allow person inflating the tire to stand to the side. Serious injure could result if the tire and rim were to separate. Hydraulic accumulators are filled with nitrogen and operate under high pressure. For safe operation observe the following precautions: if the accumulator is damaged or operates incorrectly refer to authorized service station for servicing the accumulator must be filled with nitrogen only by personnel authorized for servicing high pressure equipment never tap the accumulator nor expose to fire. Do not perform any welding nor cutting holes in it relieve nitrogen completely thru vent valve prior to repair or disposal.
DRESSTA OM560C99/1E