SECTION 2 SAFETY PRECAUTIONS Page 10 2.5. WHEN PARKING Avoid parking on a slope. If necessary to park on a slope, park at a right angle to the slope and block the tires. Park the machine in place free from grease and fuel to prevent tire damage. Never leave the machine with the engine running or the bucket raised. When parking the machine, shut off the engine, lower the bucket to the ground, lock the transmission shift lever in neutral (N), apply the parking brake, turn off the electrical system disconnect switch, and remove the key . Park the machine in a nontraffic area. If parking near or in traffic lanes cannot be avoided, identify the machine in accordance with traffic rules.
Always lock the machine, including any anti-vandalism attachments when leaving it unattended. If the loader is equipped with a multi-purpose bucket, close the clam before dismounting. When operating in bad weather and storm lightning is nearby, dismount and seek shelter away from the machine. Lightning will be attracted to the machine and cause serious injury or death. ADDITIONAL INFORMATION 1. Wheel Loader has CE mark - declaration of conformity with EEC directive of March 18,1998. 2. Wheel Loader has TBG certificate (Tiefbau-Berufsgenossenschaft) No 612.17/242 Sp-061 awarded on March 30,1998. 3.
The Loader complies with „B” Safety Mark Requirements according to State Certificate No 015/98 (being upgraded). 4. The Loader was given TЬV Hannover Laboratory DE 10-893 641 11 Noise Level Certificate on 17 March 1998. 5. Wheel Loader in standard configuration is not adapted to operation in terrain where a mixture of gasses, vapors, aerosols or dust with air create explosion hazard zones. OM560C99/1E DRESSTA