1. COMMON MODEL INFORMATION TERMINAL SERVICE KIT A REFERENCE GUIDE CONNECTORS WITH A SECONDARY LOCK Male Terminal Half n SPECIAL CONNECTORS out of the connector with needle-nose PIN TOOL F w - 1 here, and push the I lock out. Hold pin tool firmly by the handle with the pin tool in the down position. Hold connector housing with attachment tab on the top facing toward you. Place the tip of the pin tool toward the front of the release tab on the top of the terminal top. While pressure is applied to the release tab with the pin tool, pull the connector housing from the terminal. PINTOOLF 1 / (PIN 07JAZ-002060A) Female Terminal Half (PIN 07JAZ-O02060A), Remove the secondary lock. PIN TOOL F 1.
Push the wire into the connector to relieve the tension on the primary lock. 2. Insert the tool at the middle of the terminal. 3. Push down on the tool to lift up on the primary lock. 4. Pull the connector out of the terminal. female). Remove the terminal (same procedure for male and 1. Push the wire into the connector to relieve the tension on the primary lock. 2. Insert the tool under the terminal and lift up. 3. Pull the terminal out of the connector. 1150 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.