1. COMMON MODEL INFORMATION DUAL OUTBOARD INSTALLATION TRANSOM CENTER LINE BF200AI225A, BF115A/130A, BF75AI90A Measure across the transom to determine the transom center line and draw a vertical line. On a “ V bottom boat, the vertical line should pass through the keel. Use a pencil and tape measure to locate center line. 432 mm 432 mm (17 in) (17 in) minimum minimum u ! u MARK FIRST U 660 mm (26 in) minimum Dual outboards must be installed so the outboard center-to-center distance is a minimum of 660 mm (26 in). The transom board should still have a minimum extra space of 432 mm (17 in). Be sure the boat is well-balanced. Mount the counter-rotation outboard on the port side.
B F40AIB F50A I. Put one end of the tape measure on a chine and place the other end on the upper edge of the transom, somewhere past the “visual” center. Place a mark on the transom and record the distance measured. MARK SECOND 432 mm 432 mm (17 in) (17 in) minimum ! minimum I I- I ! I 2. Measure the same distance from the opposite chine and make a mark. U 610 mm (24 in) minimum Dual outboards must be installed so the outboard center-to-center distance is a minimum of 610 mm (24 in). The transom board should still have a minimum extra space of 432 mm (17 in). Be sure the boat is well-balanced. 1121 Date of Issue: June 2003 0 2001-2003 American Honda Motor Co., Inc.