И EBS00167 ASSEMBLING THE REAR CONSTANT VELOCITY JOINTS 1. Install: dust boot clip 1 off-set joint 2 joint shaft 3 1 New 3 MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Install the clip 1 . b. Install the off-set joint 2 . И 3 NOTE: Install the clip 1 into the groove in the joint shaft as shown. Secure the off-set joint in a vise, and then fit the joint shaft into the off-set joint using a hammer. 1 2 LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL И Wheel side И Й 2. Install: dust boot ball bearing 1 circlip 2 double off-set joint 3 clip 4 1 2 New New NOTE: Securely install the circlip into the groove in the joint shaft.
Securely install the clip into the groove in the double off-set joint. Й Й Gear case side 3 4 7 - 28 REAR CONSTANT VELOCITY JOINTS AND FINAL DRIVE GEAR DRIV DRIV