3. Apply: molybdenum disulfide grease (into the ball joint assembly) NOTE: _ Molybdenum disulfide grease is included in the repair kit. 4. Install: dust boots 1 boot bands 2 , 3 New MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Apply molybdenum disulfide grease into the dust boots. Molybdenum disulfide grease 40 g (1.4 oz) per dust boot (rear wheel side) 60 g (2.1 oz) per dust boot (final gear case side) b. Install the dust boots 1 . c. Install the dust boot bands. NOTE: _ The new boot bands may differ from the orig- inal ones. The dust boots should be fastened with the boot bands 3 at the grooves in the joint shaft. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 5. Check:
thrust movement free play Excessive play Replace the joint assem- bly. 7 - 29 REAR CONSTANT VELOCITY JOINTS AND FINAL DRIVE GEAR DRIV DRIV