MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Connect the positive tester probe to termi- nal 1 and the negative tester probe to ter- minal 2 , and check the continuity. b. Connect the positive tester probe to termi- nal 1 and the negative tester probe to ter- minal 3 , and check the continuity. c. If either of the readings indicate no continu- ity, replace the bulb. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL CHECKING THE CONDITION OF THE BULB SOCKETS The following procedure applies to all of the bulb sockets. 1. Check: bulb socket (for continuity) (with the pocket tester) No continuity Replace. Pocket tester 90890-03112 Analog pocket tester YU-03112-C NOTE:
_ Check each bulb socket for continuity in the same manner as described in the bulb section; however, note the following. MMM M M MMM M M MMM M M MMM M M MMM M M MMM M MMM a. Install a good bulb into the bulb socket. b. Connect the pocket tester probes to the respective leads of the bulb socket. c. Check the bulb socket for continuity. If any of the readings indicate no continuity, replace the bulb socket. LLL L L LLL L L LLL L L LLL L L LLL L L LLL L LLL 9 - 9 CHECKING THE BULBS AND BULB SOCKETS ELEC – + ELEC – +