Parameter meaning: the wear area. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. These parameters do not apply if sensors are integrated, and control is active. System Vehicle type This parameter indicates vehicle type and affects system configuration. Warning light fitted with wear sensors: If this checkbox is ticked, a warning light or a relay for switching wear display is monitored. EBS system: Start check for warning light wear sensors: Indicates the EBS system design. If this checkbox is ticked, the warning light for wear display is activated during start check. ASR ASR integrated:
ASR function is permanently activated if this checkbox is ticked. Other components Endurance brake cut-off relay present: ASR switch type: You can indicate here whether a switch (in both positions) or a push-button is fitted. If this checkbox is ticked, an endurance brake cut-off relay is controlled and monitored. Cut-off of Endurance Brake Integration (EBI): ASR switch function: You can choose here whether the ASR off-road function should be activated, or the ASR function deactivated when the ASR off-road switch is activated. Endurance brake integration is activated if the ”Endurance Brake Integration” checkbox is ticked. Endurance Brake Integration (EBI) mode:
Wear sensing This parameter is used to adjust the EBI to the city or tourist coach driving profile. The available vehicle type parameter settings should only be changed with the consent of the vehicle manufacturer, or by WABCO. Wear control: If this parameter is not activated, only wear control will be possible, irrespective of whether or not sensors are integrated. Trailer control valve present: If this checkbox is ticked, a trailer control valve is controlled and monitored. Wear sensors present: Tire circumferences: If wear sensors are fitted on the front and rear axles and must be evaluated, this checkbox must be ticked. Standard setting: ”Wear sensors present”.
The rolling circumference of the tire equipment must be entered here according to the vehicle manufacturer or tire equipment manufacturer’s specifications. Permitted values for Pole wheel 100Z is 2550 to 3850, step size 25 mm. Difference between parameter value and tire circumference: maximum 5%. DV1_15 and DV2_15: Basic braking pressure settings: VA to HA or HA to ZA in Parameter setting 8. EBS 30