Settings: Display ECE R13 Memory error: If this checkbox is ticked, the error memory bit required in ECE R13 are displayed when certain errors occur. Z-soll-Rьck: This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. Drag torque control released: Drag torque control is released if this checkbox is ticked. V-Start-Rьck Extended ABS control released: This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO.
Extended ABS control is released if this checkbox is ticked. AZ1: Light ASR integrated: This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. This parameter indicates that the warning light is directly controlled by the EBS control device, and that the exit is monitored. Alternatively, the information can be evaluated on the SAE bus. BV1 and RBV2: Yellow warning light present: This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO.
This parameter indicates that the warning light is directly controlled by the EBS control device, and that the exit is monitored. Alternatively, the warning light information can be evaluated on the SAE bus. AV1 and AV2: Red warning light present: This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. This parameter indicates that the warning light is directly controlled by the EBS control device, and that the exit is monitored. Alternatively, the information can be evaluated on the SAE bus. Retarder inclination: Deactivate roller lock / halt brake:
This parameter is used to coordinate braking force distribution. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. This parameter is used to lock both functions. Nominal pressure HSB VA, HA and ZA: The nominal pressure for the halt brake and roller lock of the front axle, rear axle, and possibly of the additional axle is entered here. The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. Parameter value x 0.05 bar = nominal pressure. I-Getriebe: This parameter is used to coordinate braking force distribution.
The value should only be changed according to the specifications of the vehicle manufacturer, or by WABCO. Parameter setting EBS 8. 31