Controls Trim Controls Trimming (raising and lowering the drive) can be per- formed by using: A separate control panel ( 4 ) on the instrument panel. A control button ( 5 ) on the remote control lever. The control buttons on the port control lever in a twin installation. The current trim position is indicated on a trim gauge located on the instrument panel or elsewhere on the dashboard. Operating Trim Controls Control Panel The control panel has two standard buttons for tilt con- trol with a third (optional) button: 7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06 The center button moves the drive trim out while raising the boat’s bow.
The lower button moves the drive trim in while lowering the boat’s bow. 22766 The top button (optional) disconnects a “catch” so that the drive can be trimmed into the BEACH and LIFT positions. (Press this button and the center button at the same time.) Remote Control Lever The control button on the control lever has two func- tions: Pressing the top half of the button moves the drive trim out while raising the boat’s bow. Pressing the bottom half of the button moves the drive trim in while lowering the boat’s bow. 22767 You must press a separate switch on the instrument panel to disconnect the “catch” (optional) so that the drive can be trimmed into the BEACH and LIFT posi- tions.
Control Lever with Catch Button (Single) A switch on the control lever ( 6 ) allows you to trim the drive as follows: Pressing the switch up moves the drive trim out while raising the boat’s bow. Pressing the switch down moves the drive trim in while lowering the boat’s bow. The catch button ( 7 –optional) disconnects a “catch” so that the drive can be trimmed into the BEACH and LIFT positions. 22768 VPA 7743722 English 10-2004 33