Operation Starting the Engine (Cold Start) GL Models A cold engine may require priming before you can start it. To prime the engine: 1. Turn the ignition switch OFF ( 0 ). 2. Disengage the drive mechanism by pressing the gear shift release button ( A ). 3. Depress the throttle lock and move the control lever to FULL THROTTLE ( B ) in order to activate the accelerator pump and prime the engine. 4. Return the remote control handle to a fast idle position (about 1000 RPMs). 5. Turn the ignition switch to START ( II ) and hold it there until the engine starts, but for no longer than 10 seconds. 21183-1 6.
Once the engine starts, keep the throttle at a fast idle (about 1000 RPMs) for 30 seconds before returning to NEUTRAL. 7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06 7. Repeat priming if necessary. CAUTION! Too much priming may flood the en- gine. If the engine fails to start after a few at- tempts, there may be a problem that needs to be addressed. See your authorized Volvo Penta dealer for service. 21181 Gi & GXi Models 1. Move the control handle to the NEUTRAL detent position. 2. Turn the ignition switch to START ( II ) and hold, for no longer than ten seconds or until engine starts. If the engine does not start, let go momentarily, then try again. 3.
As soon as engine starts, release key to ON or RUN ( I ). If the Engine Floods GL Models 1. Disengage the shift mechanism. 2. Move the remote control lever to FULL THROTTLE ( B ). 3. Turn the key switch to START ( II ). 4. As soon as the engine starts: Return the remote control handle to IDLE. Turn the key to ON or RUN ( I ). Move the remote control handle to FAST IDLE to warm up the engine. Do not exceed 1000 RPM. 36 VPA 7743722 English 10-2004