Maintenance Power Steering Reservoir Fluid Level Whenever you check the engine oil, also remove the steering reservoir dipstick and check the fluid level. Wipe the dipstick and note the “hot” and “cold” fluid levels. If needed, add Volvo Penta Power Trim/Tilt and Steering Fluid. Do not overfill the pump reservoir. CAUTION! Never fill the steering system with an oil of unknown quality. Non-recommended oil may cause steering operation impairment or component damage. Do not allow contaminants to enter the reservoir when checking or filling the oil level. Power Trim/Tilt Fluid Level The power trim and tilt assembly contains an electric motor, hydraulic pump, and reservoir.
At the beginning of each boating season, check the fluid level in the reservoir: 7743722 - Downloaded from www.volvopenta.com 13/05/2008 20:17:06 1. With the drive unit trimmed in (down) as far as possible, remove the fill cap E . 2. Check the fluid level. It should be between the minimum and maximum marks ( D & C ) on the reservoir. If needed, add Volvo Penta Power Trim/Tilt and Steering Fluid. 3. Replace the fill cap and tighten securely. 47564 Shaft Spline and Bearing Lubrication The primary shaft and bearings must be lubricated each year and whenever the drive unit is removed. This procedure requires the removal of the drive unit; therefore, your Volvo Penta dealer should do it.
An ideal time to have this done is during the winterization process or in the spring when preparing to launch for the first time. Failure to have primary shaft splines and bearings lubricated each year may result in damage to the drive unit. Tie Rod (Twin Installations Only) Check the rod connecting the drive units, particularly if you hit an obstacle. If the tie rod is bent, loose, or damaged, have it serviced immediately by your Volvo Penta dealer. In the meantime, operate your boat at slow speeds only. WARNING! The tie bar is an integral part of the steering system and is a vital safety part. A damaged tie rod may hinder steering oper- ation or render it completely ineffective.
Al- ways replace a damaged tie bar. Never try to straighten or weld a damaged tie rod. 22853 VPA 7743722 English 10-2004 89