OM2221 8/11 Safety - Section 22 Page 22-7 SPRING PRESSURE EMERGENCEY EGRESS This danger plate is mounted on each brake assembly. It warns the service technician that there are springs inside the brake assembly under pressure. Refer to the shop manual for proper procedure to safely disassemble the brake assembly. This caution decal is placed near both vertical ladders on either side of the radiator. It informs personnel that these ladders are intended for emergency use only. The diagonal ladder in front of the radiator is the preferred ladder to use.
ROPS/FOPS A plate attached to the right rear corner of the cab states that the Rollover Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) meet various ISO performance requirements. Wireless Signal The plate also contains a WARNING about making modifications or repairs to the structure. Unauthorized modifications or repairs will void the certification. Wireless signals from the trucks KOMTRAX Plus system (if equipped with ORBCOMM) can interfere with other wireless signals in the area. This interference can cause a malfunction in a blast zone resulting in an unintended detonation.
Know the location of blast zones in the area and keep a safe distance to avoid unintentional blasts. The KOMTRAX Plus system uses frequencies 148Hz to 150Hz . OIL FILL AND CHECK A wheel motor oil level decal is attached to the gear cover on both electric wheel motors. This decal stresses the fact that the truck must be on a level sur- face and parked for 20 minutes prior to checking the oil level. This is necessary in order to get an accurate reading.