Text-module PM-Picturemodule 3) VISCOSITY OF OILS IN ENGINE Monograde oils Multigrade oils PMTAB_Picture 1) As indicated on dipstick, by overflow from filling point etc. 2) Whichever is the sooner. 4) For permitted tradenames, if specified, see current fuels and lubricants list which all Fendt dealers receive as a service circular. 5) If diesel fuel contains more than 0.5 - 1% sulphur, oil-change intervals must be halved. A sulphur content of less than 0.05% is recommended, though the fuel supplier must confirm that an adequate lubricant effect is guaranteed (e.g. by means of additives). Only use alternative fuels, e.g. RME, once discussed with the Service Workshop .
Text-module Fav 900 chassis number 23/3001 and up General Fav 900 Tractor / General system Fuels and lubricants A Filling points Filling quantity Type 4) Frequency of change 2) approx. litres Engine "Max" with filter change 24 All-year SHPD engine oil 3) to ACEA E3-96 After 50, 500, 1000 op. hrs. then every 500 op. hrs. though at least once a year if sulphur content is up to 0.5% 5) Transmission and differential (refill) 65 STOU SAE 10 W-40 or 15 W-40 then every 2 years or every 2000 operating hours.
Power lift shaft lubrication 0.2 Power lift shaft lubrication (top-up- only) after 50 operating hours and in event of leaks Axle drives per side 13 Special hypoid transmission oil Every 500 operating hours SAE 85 W-90 or SAE 80 W-90 then every 2 years or SAE 90 as per API GL-5 or every 2000 op. hrs. Front axle differential 9.5 No STOU or other universal oil Front axle differential and hub drives Hub drives per side 2.7 After 50 then 1000 op. hrs, then every 2 years or 2000 op. hrs. Front PTO 4.2 After 500 op. hrs, then every 2 years or 2000 op. hrs. Rear axle stub shaft (optio- nal) axle drivers per side 13 Special hypoid transmission oil 85 W-140 to API GL-5 After 500 op.
hrs, then every 2 years or 2000 op. hrs. Hydraulics STOU SAE 10W-30, 10W-40, 15W-30 After 1000 op. hrs. Quantity for max. filling 70 Also permissible: HD-SAE 20 W-20 to API-CD then every 2 years or every 1000 op. hrs.
Fuel tank 530 Diesel 5) Fill up after use Cooling system 26 Water with 35 - 50% vol/vol anti- freeze and anti-corrosion agent Change antifreeze every 2 years Brake and clutch system 0.8 Pentosin CHF 11S Every 2 years (X 902.011.622) Air compressor 0.5 Ethyl alcohol antifreeze Fill up only below + 5°C (X 902.015.003) Lubrication points Lithium-saponified grease, NLGI class 2 See Lubrication Chart see Lubrication Chart (worked penetration coefficient 265-295) -regularly oil all other joints and bearing surfaces Date Version Page Fuels and lubricants Capitel Index Docu-No. 12.11.2001 a 1/2 0000 A 000029