SEN00056-01 00 Index and foreword Standard tightening torque table 1 1. Table of tightening torques for bolts and nuts a Unless there are special instructions, tighten metric nuts and bolts to the torque below. (When using torque wrench) a The following table corresponds to the bolts in Fig. A. a The following table corresponds to the bolts in Fig. B. a Fig. A a Fig.
B 24 D65EX, PX, WX-15E0 Thread diameter of bolt Width across flats Tightening torque mm mm Nm kgm 6 8 10 12 14 10 13 17 19 22 11.8 – 14.7 27 – 34 59 – 74 98 – 123 153 – 190 1.2 – 1.5 2.8 – 3.5 6 – 7.5 10 – 12.5 15.5 – 19.5 16 18 20 22 24 24 27 30 32 36 235 – 285 320 – 400 455 – 565 610 – 765 785 – 980 23.5 – 29.5 33 – 41 46.5 – 58 62.5 – 78 80 – 100 27 30 33 36 39 41 46 50 55 60 1,150 – 1,440 1,520 – 1,910 1,960 – 2,450 2,450 – 3,040 2,890 – 3,630 118 – 147 155 – 195 200 – 250 250 – 310 295 – 370 Thread diameter of bolt Width across flats Tightening torque mm mm Nm kgm 6 8 10 12 10 13 14 27 5.9 – 9.8 13.7 – 23.5 34.3 – 46.1 74.5 – 90.2 0.6 – 1.0 1.4 – 2.4 3.5 – 4.7 7.6 – 9.2