GETTING TO KNOW YOUR VEHICLE 33 Power Lumbar — If Equipped greater than or equal to 2.7inches (67.7mm) forward of the rear stop. The seat will return to its previously set position when you place the ignition into the ACC or RUN position. WARNING! Vehicles equipped with power driver or passenger seats may also be equipped with power lumbar. The power lumbar switch is located on the outboard side of the power seat. Push the switch forward to increase the lumbar support. Push the switch rearward to decrease the lumbar support.
Persons who are unable to feel pain to the skin because of advanced age, chronic illness, diabetes, spinal cord injury, medication, alcohol use, exhaustion or other physical condition must exercise care when using the seat heater. It may cause burns even at low temperatures, especially if used for long periods of time. When you place the ignition in the OFF position, the driver’s seat will move to a position 0.3inches (7.7mm) forward of the rear stop if the driver’s seat position is between 0.9inches and 2.7inches (22.7mm and 67.7mm) forward of the rear stop. The seat will return to its previously set position when you place the ignition to the ACC or RUN position.
2 Do not place anything on the seat or seatback that insulates against heat, such as a blanket or cushion. This may cause the seat heater to overheat. Sitting in a seat that has been over heated could cause serious burns due to the increased surface temperature of the seat. The Easy Entry/Exit feature is disabled when the driver’s seat position is less than 0.9inches (22.7mm) forward of the rear stop. At this posi tion, there is no benefit to the driver by moving the seat for Easy Exit or Easy Entry. Lumbar Control Switch When enabled in Uconnect Settings, Easy Entry and Easy Exit positions are stored in each memory setting profile Ъ page29.
The heated seats control buttons are located on the center instrument panel below the touchscreen, and are also located within the climate or controls screen of the touchscreen. Front Heated Seats Easy Entry/Exit Seat This feature provides automatic driver’s seat positioning to enhance driver mobility when entering and exiting the vehicle. NOTE: The Easy Entry/Exit feature is enabled or disabled through the programmable features in the Uconnect system Ъ page189. H EATED S EATS — I F E QUIPPED The distance the driver’s seat moves depends on where you have the driver’s seat positioned when you remove the key fob from the ignition. Push the heated seat button once to turn the HI setting on.
On some models, the front and rear seats may be equipped with heaters located in the seat cushions and seatbacks. Push the heated seat button a second time to turn the MED setting on. When you place the ignition in the OFF position, the driver’s seat will move about 2.4inches (60mm) rearward if the driver’s seat position is