MAY 2003 13. Make sure the protective cover gap is toward the engine and the closed end is toward the throttle body. 14. Position the end of the protective cover 45 - 50 mm (1.75 - 2.0 in) from the main harness band clip as shown. 15. Secure the protective cover to the main harness with the tie-wrap as shown. Cut the end of the tie- wrap to a length of 5 mm (0.2 in). PROTECTIVE COVER TIE-WRAP 45 - 50 mm (1.75 - 2.0 in) JOINT CONNECTOR HARNESS THROTTLE BODY TIE-WRAP 5 mm (0.2 in) MAIN HARNESS PROTECTIVE COVER END GAP PROTECTIVE COVER ENGINE MAIN HARNESS BAND CLIP 16. Reassemble the engine in the reverse order of its disassembly.
Be sure the throttle cables are not twisted when installing the throttle body. Tighten the throttle body 8 mm flange bolts to the specified torque. TORQUE: 8 mm flange bolt - 22 N•m (16 ft-lb) 17. Proceed to the Warranty Information (page 19) after the update has been completed. Page 5 of 2 0