MAY 2003 14. Remove the intake manifold by loosening the seven 8 x 50 mm flange bolts, 6 x 32 mm flange bolt and two 8 mm flange nuts in two or three steps following the following the reverse order of the sequence shown below (example 10, 9, 8, 7, 6...1). 15. Remove the intake manifold. The throttle body was removed in the Inspection Procedure . Page 10 of 2 0 INTAKE MANIFOLD GASKET Inspect. INTAKE MANIFOLD GASKET Inspect. INTAKE MANIFOLD SPACER 8 x 50 mm FLANGE BOLT (7) 6 mm FLANGE NUT (2) Installation sequence shown. Removal is in reverse order. 6 x 32 mm FLANGE BOLT