MAY 2003 21. Move the remote control lever to the NEUTRAL position. 22. Check whether the “ T “ mark on the throttle cam aligns with the center of the throttle lever roller. T MARK THROTTLE CAM 23. If the “ T “ mark on the throttle cam does not align with the center of the throttle lever roller, move the CLOSE side adjusting nut up or down as necessary. 24. Tighten the CLOSE side lower lock nut. THROTTLE LEVER ROLLER 25. After all adjustments have been made, move the remote control lever to the full throttle position and check that the throttle lever has a 1 mm (0.04 in) gap or less at the full throttle stop. Readjust if necessary. THROTTLE LEVER 1 mm (0.04 in) OR LESS 26.
After reassembly, start the engine and check the throttle operation and for proper engine idle. FULL THROTTLE STOP Page 18 of 2 0