SERIES 60 ON-HIGHWAY ENGINE OPERATOR'S GUIDE Replace Fuel Pro® 382/382E Fuel Filter Element The system also includes a fuel heater element, thermostatic switch and wiring harness. The Fuel Pro 382/383E diesel fuel filter system consists of a permanently mounted fuel processor, a replaceable filter element and sealing grommet assembly, a filter spring, a see-thru cover and seal, a cover collar, and a vent cap and seal. See Figure 24. Replace the element as follows: 1. Shut down the engine and allow it to cool. 2. With the engine at ambient temperature and cool to the touch, place a suitable container under the filter. 3.
A fuel shutoff valve may be installed on the discharge side of the fuel filter. If installed, turn the handle on the shutoff valve to the closed position (perpendicular to the valve). 4. Open the drain valve at the base of the fuel processor and drain the fuel until it is below the bottom of the filter in the see-thru cover. Close the drain valve. The fuel may be returned to the tank. 5. Using filter collar/vent cap wrench part number 232002 or equivalent, remove the collar by turning counter-clockwise. Remove the cover, filter spring and cover seal ring by lifting straight up and over the filter element. Figure 24 Fuel Pro 382E Fuel Processor Assembly 6.
Remove the element from the center stud (fuel outlet pipe) All information subject to change without notice. 85 DDC-SVC-MAN-0039 Copyright © 2009 DETROIT DIESEL CORPORATION