SAFE OPERATION - 4 10.Set the implement lowering speed knob in the "LOCK" position to hold the implement in the raised position. 4. OPERATING THE PTO 1. Wait until all moving components have completely stopped before getting off the tractor, connecting, disconnecting, adjusting, cleaning, or servicing any PTO driven equipment. 2. Keep the PTO shaft cover in place at all times. Replace the PTO shaft cap when the shaft is not in use. (1) 3-point hitch lowering speed knob (A) "FAST" (B) "SLOW" (C) "LOCK" 3. PARKING THE TRACTOR 1.
Disengage the PTO, lower all implements to the ground, place all control levers in their neutral positions, set the parking brake, stop the engine, remove the key from the ignition and lock the cab door (if equipped). Leaving transmission in gear with the engine stopped will not prevent tractor from rolling. 2. Make sure that the tractor has come to a complete stop before dismounting. 3. Avoid parking on steep slopes, if at all possible park on a firm and level surface; if not, park across a slope with chock the wheels. Failure to comply with this warning may allow the tractor to move and could cause injury or death.
(1) PTO Shaft cover (2) PTO Shaft cap (A) "NORMAL POSITION" (B) "RAISED POSITION" 3. Before installing or using PTO driven equipment, read the manufacturer's manual and review the safety labels attached to the equipment. To prevent PTO driven equipment from improper or unsafe use, select the lower speed (540rpm) unless the higher one is specifically recommended as safe by the equipment manufacturer. 4. When operating stationary PTO driven equipment, always apply the tractor parking brake and place chocks behind and in front of the rear wheels. Stay clear of all rotating parts. Never step over rotating parts.