Instructions for ST assembly 210 MW Bandel India Document number: S12003-YK09-05MAA-747002 Tylova 57l 31600 Plzeň l Českб Republika All the following instructions are valid for the first assembly of turbo-set and also for the repeating of assembly after moving of TG to the another place or for the assembly carried out after every opening of turbine casing due to the planned overhaul period or a any repair. These instructions would be partly useful also for the future maintenance.
Veškerй n бsledujнcн instrukce jsou platnй pro prvnн montбž turbosoustrojн i pro opakovanou montбž v přнpadě přestěhovбnн turbiny do jinй lokality, pro montбž provбděnou po každйm otevřenн turbiny za ъčelem plбnovanй revize nebo opravy. Tyto pokyny jsou čбstečně využitelnй i pro budoucн ъdržbu. Rotor turbiny při ъdržbě na elektrбrně nebo při transportu mimo elektrбrnu musн bэt vždy upevněn v transportnнm stojanu (stojan je dodбn spolu s turbinou). The turbine rotor during maintenance or transport out of the power plant has to be attached into the transport stand (the stand is part of turbine delivery).
During developing of this manual it was considered that all assembly works will be carried out by technical advisory service of DSPW staff, all of the information contained herein are adapted to this assumption.
DSPW technical advisor for turbine assembly has the right to change the standard assembly sequences and time schedule contained in this manual if it is required to the actual situation on site (change of part delivery, substandard condition on workplace and binding between activities of sub suppliers on site, Při tvorbě tohoto manuбlu bylo uvažovбno, že veškerй montбžnн prбce budou vykonбny formou technickйho poradenstvн zajištěnйho pracovnнky DSPW ; veškerй zde uvedenй informace jsou přizpůsobeny tomuto předpokladu.
Poradce pro montбž turbнny DSPW тб prбvo měnit standardnн postup prбcн a harmonogram uvedenэ v tomto manuбlu pokud to vyžaduje aktuбlnн situace na staveništi (změny v dodбvkбch dнlů, nestandardnн podmнnky na pracovišti, vazby s činnostmi ostatnнch dodavatelů na staveništi, řešenн nečekanэch Date: 12.11.2013 Page 18 / 278 Prepared: O.Baroch Last Revision: Approved: P.Lešetickэ LAY-OUT DRAWINGS – civil part Name of drawing No. TG foundation –Dimensional drawing Pt6005347 LAY-OUT DRAWINGS – mechanical part Name of drawing No.
DD - Lay-out drawing + 9,00 m Pt6005221 DD - Lay-out drawing + 0,00 m Pt6005222 DD - Lay-out drawing - 3,60 m Pt6005919 DD - Lay-out drawing longitudinal section A-A Pt6005223 DD - Lay-out drawing longitudinal section B-B Pt6005225 DD - Lay-out drawing longitudinal section C-C Pt6005226 DD - Lay-out drawing longitudinal section D-D Pt6005227 DD - Lay-out drawing cross section 1 – 1 Pt6005228 DD - Lay-out drawing cross section 2 – 2 Pt6005229 DD - Lay-out drawing cross section 3 – 3 Pt6005230 DD - Lay-out drawing cross section 4 – 4 Pt6005231 2 Assembly arrangement / Pokyny pro montáž 2.1 Introduction / Úvod