Prevention B. Throttle The throttle should have a free, smooth range of motion. If it seems to “stick” at any point, refer to the General Maintenance section of this Operator’s Manual for instructions. Driving your ATV with a sticking throttle can turn your leisurely ride into an unwelcome accident. Don’t drive your ATV if the throttle sticks. CHECK: 1. Free, smooth range of 1. motion LIGHTS AND ELECTRICAL Turn the hi-beam and lo-beam on and off to make sure they work. At the same time, check that the taillight, brakelight, turn lights, hazard warning lights, number plate light and horn work.
Also, check the indicator/ warning lights (turn lights, hi beam and temperature) on your handlebars when you start the ATV. Don’t drive the ATV unless all systems are working. Check the ignition switch. CHECK: 1. Hi-beam 2. Lo-beam 3. Tailight/brakelight 4. Indicator/warning lights 5. Position lights CHECK: 1. Hazard warning lights 2. Ignition switch OIL AND FUEL Start with a full tank of gas before every ride, and while you’re at it, top off the oil. Don’t forget to check for fl uid leaks around the ATV. CHECK: 1. Gas 2. Oil 3. Fluid leaks CHASSIS AND SUSPENSION Grass and leaves can gum-up your suspension and shocks. Clear and clean the suspension arms, shock absorbers/springs, and fenders.
Check smoothness by turning the handlebar full-left and full-right. Check that there is no binding, restrictions, freeplay, or looseness in steering components. CHECK: 1. Suspensions arms 2. shock absorbers/springs 3. Steering 4. Drive chain 28