GETTING TO KNOW YOUR VEHICLE 23 B ASIC V OICE C OMMANDS MIRRORS The basic Voice Commands below can be given at any point while using your Uconnect system. I NSIDE R EARVIEW M IRROR Push the VR button . After the beep, say: Manual Mirror — If Equipped “Cancel” to stop a current voice session. “Help” to hear a list of suggested Voice Commands. The rearview mirror can be adjusted up, down, left, and right. The mirror should be adjusted to center on the view through the rear window. 2 Headlight glare from vehicles behind you can be reduced by moving the small control under the mirror to the night position (toward the rear of the vehicle).
The mirror should be adjusted while set in the day position (toward the windshield). Notice the visual cues that inform you of your Voice Recognition system’s status. G ET S TARTED “Repeat” to listen to the system prompts again. Uconnect Voice Command Buttons 1 — Push To Mute 2 — Push To Initiate Or To Answer A Phone Call, Send, Or Receive A Text 3 — Push To Begin Radio, Media, And Navigation 4 — Push To End Call The VR button is used to activate/deactivate your Voice Recognition system. Helpful hints for using Voice Recognition: Reduce background noise. Wind noise and passenger conversations are examples of noise that may impact recognition. A DDITIONAL I NFORMATION © 2021 FCA US LLC.
All rights reserved. Mopar and Uconnect are registered trademarks and Mopar Owner Connect is a trademark of FCA US LLC. SiriusXM® and all related marks and logos are trademarks of SiriusXM® Radio Inc. Speak clearly at a normal pace and volume while facing straight ahead. Each time you give a Voice Command, first push the VR button, wait until after the beep, then say your Voice Command. Manual Mirror Adjustment You can interrupt the help message or system prompts by pushing the VR button and saying a Voice Command from the current category. For Uconnect system support, call 1-877-855-8400 (24 hours a day 7 days a week) or visit DriveUconnect.com (US) or DriveUconnect.ca (Canada) Ъ page 236.