26 GETTING TO KNOW YOUR VEHICLE D AYTIME R UNNING L IGHTS (DRL S ) — I F E QUIPPED F LASH -T O -P ASS Deactivation You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will cause the high beam headlights to turn on, and remain on, until the lever is released. P ARKING L IGHTS Pull the multifunction lever toward the steering wheel and hold it for more than two seconds. F OG L IGHTS — I F E QUIPPED The Daytime Running Lights (DRLs) will come on whenever the ignition is in the ON position, the headlight switch is off, and a turn signal has not been activated.
The fog light switch is located on the center stack of the instrument panel, just above the climate controls. To activate the DRLs, rotate the end of the multifunction lever to the O (Off) position. These lights can only be turned on with the ignition in the STOP (OFF/LOCK) position or removed. Move the end of the multifunction lever to O (off) position, and then to the headlight position. Push the switch once to turn the fog lights on. Push the switch a second time to turn the fog lights off. NOTE: For vehicles sold in Canada, the Daytime Running Lights will automatically deactivate when the front fog lights are turned on. The indicator light telltale in the instrument panel comes on.
The lights stay on until the next ignition cycle is performed. F OLLOW M E H OME /H EADLIGHT D ELAY NOTE: If the vehicle’s ignition is turned off, the fog lights will also turn off. T URN S IGNALS The low beams and side/taillights will not be on with DRLs. In certain markets, the DRLs can be programmed on or off through the Uconnect system Ъ page 78. Move the multifunction lever up or down to activate the turn signals. The arrows on each side of the instrument cluster flash to show proper operation. When this feature is selected, the driver can choose to have the headlights remain on for a preset period of time after the engine is turned off.
On some vehicles, the Daytime Running Lights may deactivate, or reduce intensity, on one side of the vehicle (when a turn signal is activated on that side), or on both sides of the vehicle (when the hazard warning lights are activated). H IGH /L OW B EAM S WITCH Activation Remove the key or turn the ignition to the STOP (OFF/LOCK) position, and pull the multifunction lever toward the steering wheel within two minutes. Each time the lever is pulled, the activation of the lights will be extended by 30 seconds. The activation of the lights can be extended to a maximum of 210 seconds. NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. Pull the multifunction lever toward the steering wheel to switch the headlights to high beams. Pull the multifunction lever again to turn the low beams back on.