SAFETY RULES FOR ROAD TRAVEL Traveling with your machine may pose some hazards. When traveling, always travel in a safe manor and remain alert at all times A safety conscious operator is the most important insurance when traveling with the machine. Below are several situations and information the operator should be aware of: 1. Raise the loader bucket to a safe travel height of 40-50 cm (16-20 in) from the ground, lock the loader control levers using the safety lock equipped with the machine. 2. Obey all traffic rules when traveling on local and state roads. Always travel at a safe controllable speed. 3. Never turn the ignition key off when traveling.
If the engine should stop, apply the brakes and stop the machine immediately. 4. Always be aware of your clearances and road surface. Some areas may not support the weight of your machine. Plan your rout in advance. If necessary, obtain the aid of an escort to lead or prepare your travel rout. 5. Never travel at high speeds, loss of control or tire damage may result. TRAVELING IN REVERSE Traveling in reverse may pose several hazards. Below is a list if some basic rules to follow when traveling in reverse: Be sure the area behind you is clear of people or objects that might be in the way Before moving your machine, sound the horn to warn others in your area you are moving.
When operating in areas that may pose a hazard or has poor visibility, designate a person to direct your movements. Do not rely totally on you machines mirrors, keep in mind there are blind spot when using the mirrors. TRAVELING ON ICY OR SNOW-COVERED SURFACES If the ground is icy or covered with snow, the response of the machine to the movements of the steering wheel may not be as precise as expected. To limit the risk resulting from reduced maneuverability, proceed as follows: Travel at a slow safe speed. Avoid rapped accelerations or breaking. Remember your stopping distances are reduced during slippery conditions.
WORKING ON LOOSE OR UNSTABLE GROUND To limit the risk when working in these areas: Avoid operating the machine too close too the edge of a cliff, open trenches or ditch lines. These areas may collapse under the weight of your machine causing serious damage to the machine or injury to the operator. Keep in mind after a heavy rain or thaw, the surface conditions become worse and less stable. 1-12 WA480-5L