5 . Replace the flywheel housing sealing (1) . Smear sealing compound (p/n 840879) on the edge between the flywheel housing and the sealing . NOTE! The sealing lip with a spring shall be turned towards the engine . Make sure that the sealing is installed in accordance with the picture . 7A . Heat the camshaft gear wheel to a temperature of approx . 150°C (302°F) and use a suitable sleeve to install it . Check to make sure that the gear wheel "bottoms" on the camshaft . Install the camshaft and make sure that the markings on the camshaft gear wheel and on the crankshaft gear wheel coincide . Put the washer (1) on the hub of the camshaft gear wheel .
Check that all weights are presed in so that the tabs (2) are inside the washer . r 7B . Install anew sealing ring for the camshaft in the transmision housing, using mandrel p/n 884838 . The sealing lip with the spring is to beturned towards the engine . Press in the sealing ring from the outside until the mandrel "bottoms" against the housing . Install a new O-ring in the oil channel in the block (3 fig . 7A) . Use a new gasket and install the timing gear cover . Place the pressure sleeve (with the bearing towards the pressure washer) in the control arm lever . Hold the sleeve in place by pressing the lever to its bottom position where the sleeve is pressed against the housing .
Install the pin of the camshaft, using special tool p/n 884839 . The pin must 6 . Replace the O-rings and install the flywheel housing . Tightening torque 25 Nm (2,5 kpm) (18 .4 ft .lbs) . protrude equally much on both sides . Under no circumstances are you to use a hammer or some such tool to punch the pin into its location with the aid of a mandrel . The camshaft will then be bent . Install the flywheel . Tightening torque 65 Nm (6,5 kpm) (48 .0 ft .lbs).