GENERAL INFORMATION Before ordering parts, ALWAYS provide dealer with your product model number and complete serial number information. Before ordering parts, verify correct part numbers and/or serial numbers with your dealer. When using the machine serial number, use the complete number. Some Serial Number breaks are not available at time of printing. These are listed as & Bel or & Abv or -- (thru) The number shown in the quantity column in this manual is the number of parts needed for the illustration on the page. For some parts an ”x” will be shown in the quantity column. This indicates that the quantity to be used is ”As Needed”. When references L.H. (Left Hand) and R.H.
(Right Hand) are used in this manual, it is done from the operator’s seat in the forward operating position. When “See Illustration....” appears in the remarks column, refer to the contents page for the illustration title to find page number location. Some of the illustrations and information found in this parts manual were supplied to Bobcat by machine component companies. For additional information on the Bobcat website visit www.bobcat.com ABBREVIATIONS SALES = Order from Gwinner Sales Department W/ = With NSS = Not Serviced Seperately W/O = Without NAP = Not Available as Parts I.D. = Inside Diameter BTI = Bobcat Technical Information Bulletin O.D.
= Outside Diameter P/M = Parts Manual = Inches O/M = Operation & Maintenance Manual = Feet S/M = Service Manual mm = Millimeters S/L = Service Letter DISPOSITION CODE DEFINITIONS (Found in Remarks Column) [A] = Use Up [B] = Use Up on Other Application [C] = File PDR Report with Bobcat Parts Sales [D] = Part Number Error ii