Starter/Starter INSTALL STARTER—B43E, B43G, B48G, AND T260 ENGINES 1. Install starter. Tighten two cap screws to 34 ± 1 N·m (300 ± 9 lb-in.). M36439 -UN-29JAN90 Bendix Drive Starter Shown M98,2060K,72 -19-11FEB87 CTM2 (19APR90) 60-29 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495 IMPORTANT: Do not lubricate crankshaft taper. The crankshaft taper must be dry to hold the flywheel tight. 2. Clean crankshaft taper before installing flywheel. -UN-29JAN90 3. Apply pipe sealant on threads of flywheel cap screw. 4. Align keyway (A) in flywheel with key (B) in crankshaft and install flywheel. M36297 5. Install washer and cap screw. IMPORTANT:
Do not hold flywheel from turning with a pry bar in the fins. Doing so may damage the fins. 6. Fasten locking pliers to ring gear to prevent flywheel from turning. -UN-29JAN90 7. On B43E, B43G, B48G, T260 engines, tighten cap screw to 51 ± 3 N·m (38 ± 2 lb-ft). On P218G and P220G engine, tighten cap screw to M36298 67—75 N·m (50—55 lb-ft). M98,2060K,73 -19-11FEB87 60 29