Starter/Starter NOTE: For engines with adjustable starter bracket, measure starter pinion gear backlash using the following procedure. For all other units with non-adjustable starter bracket, go to Step 21. 8. Pull starter pinion gear outward until teeth contact flywheel ring gear. Measure starter pinion gear backlash. Backlash specification is 0.51 ± 0.38 mm (0.020 ± 0.15 in.). M36437 -UN-29JAN90 M36438 -UN-29JAN90 If backlash is correct, go to Step 21. 9. If backlash is not correct, loosen starter cap screws (A) and move starter bracket (B) to obtain correct backlash. Tighten starter cap screws to hold bracket in position. Check backlash again.
M98,2060K,78 -19-26NOV85 CTM2 (19APR90) 60-30 16, 18, 20 & 24HP Onan Engines AllTractorManuals.com 130495 IMPORTANT: Do not hold flywheel from turning with a pry bar. Doing so can damage the fins. 10. Fasten locking pliers to ring gear to prevent flywheel from turning. -UN-29JAN90 N CAUTION: Loosen flywheel cap screw only two turns. Do not remove cap screw. If cap screw is removed, flywheel may cause injury when it comes loose. M36292 11. Loosen cap screw two turns only. M98,2060K,9 -19-05NOV85 60 30