. OPERATION EXPLANATION OF COMPONENTS SWITCHES (1) (2) (3) (4) (5) Starting switch Speed range selector switch Variable shift control switch Traction control switch E.C.S.S. (electronic controlled suspension system) switch (if equipped) Lamp switch Turn signal lever Dimmer switch Horn button (8) (9) (10) (11) (12) (13) (14) (15) (16) (17) Hazard lamp switch Front working lamp switch Rear working lamp switch Monitor panel mode selector switch 1 Monitor panel mode selector switch 2 Front wiper switch Rear wiper switch Cigarette lighter Room lamp switch Rear heated wire glass switch (6) (6) (6) (7) STARTING SWITCH This switch (1) is used to start or stop the engine.
OFF position In this position, it is possible to insert or remove the starting switch key. All the electric system switches are off, and the engine will stop. ON position In this position, electric current flows to the charging circuit, lamp circuit, and accessory circuit. Keep the starting switch key at the ON position while the engine is running. START position This is the position to start the engine. Hold the key at this position while cranking. Release the key immediately after the engine has been started. The key will return to the ON position when released. 3 - 32