Operating AutoPowr Transmission Putting Tractor In Motion CAUTION: Avoid possible injury due to sudden or unexpected acceleration. Be aware of set speeds and throttle position before putting tractor in motion. A RXA0079023 —UN—28FEB05 NOTE: Tractor cannot be put in gear unless operator is seated. Information indicator will light and a corresponding message appears on the CommandCenter display when Forward, Reverse, or NEUTRAL positions are selected and operator is not in the seat. B RightHand Reverser Shown To initiate motion, move lever from PARK position to either Forward or Reverse position with operator seated. A—Speed Control Lever B—Speed Band NOTE:
Cold conditions may affect AutoPowr tractor performance: Engine speed will be limited to 1500 rpm if transmission oil temperature is less than 5°C (23 °F). Wheel speed is limited to 5 km/h (3.1 mph) if transmission oil temperature is less than 15°C (5 °F). NOTE: In the event of a seat switch failure, tractor can still be put into motion by cycling (depress/release) the clutch or brake pedals. Move reverser lever into Forward or Reverse position. Use throttle and speed control lever to obtain desired speed. Using the clutch to put tractor in motion is not necessary. OURX935,00004BB 1927AUG081/1 428 122208 PN=105