Command Center Vehicle Speed Calibration (Automatic) NOTE: Automatic calibration is used with John Deere Dual Beam radar. This procedure will enter a value in the radar sensor speed configuration address for the John Deere Dual Beam radar or GPS signal device requiring a configuration factor of 57.42. D C B Do not use Manual (400ft/122m) calibration for Dual Beam Radar. RXA0085829 —UN—27JAN06 Tractors not equipped with radar, but wanting to use a GPS signal require two controller addresses to be changed. Contact you John Deere dealer for assistance. A 1. Press vehicle Settings Switch (A) to view menu items on Display (D).
Rotate Command Dial (B) to highlight Speed Cal and press Select Switch (C). 2. Display will read: 400 ft (122 m) RXA0093527 —UN—24APR07 Automatic Back 3. Highlight Automatic , then press Select Switch. When Select Switch is pressed, CommandCenter will display: If Calibration is Successful If Calibration is Unsuccessful Dual Beam Radar Sensor Speed Cal Calibration Successful Speed Cal Calibration Failed A—Settings Switch B—Command Dial C—Select Switch D—Display NOTE: If failed message is received, it may be necessary to consult your John Deere dealer for assistance. If calibration is successful, perform Reset % Wheel Slip procedure if required. See RESET % WHEEL SLIP procedure.
RW29387,000005C 1920AUG081/1 1615 122208 PN=56